Automatic Setup-Mode - Selve SEL Plus Notice De Réglage

GB Setting of the end positions

4.4.1. Automatic setup-mode

in operation bottom position, top stop/release
When the movement is interrupted twice during operation, the system is in automatic
setup-mode. Motor types SEL Plus and SES will automatically find their stop positions.
For this, a motor must first move against the upper stop and then downwards until it
switches off automatically.
Setting with Setting with
switch setting switch
E
or
Drive
Move the motor upwards with the UP or DOWN
button.
The motor moves against the upper stop and
stops automatically. The correct direction of rota-
tion assignment has been made.
Continue to keep the button pressed.
The motor automatically moves downwards after
1–2 seconds. Alternatively move the motor down-
wards using the DOWN button.
Note: The motor can be moved upwards and
downwards. As long as the lower end position has
not been found, the downwards moving will be
interrupted twice.
The motor will reach the lower limit and stops
automatically.
The end positions are now set and the rotation
direction assignment is correct. Perform a test
run.
28