Manual Setup-Mode, Drive Upwards Against The Limit Stop - Selve SEL Plus Notice De Réglage

GB Setting of the end positions

4.4.3. Manual setup-mode, drive upwards against the limit stop

in operation bottom position, top stop/release
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards,
the upper end position can be set and stored. Drive against the top stop until the motor
is automatically switched off.
Setting with
setting switch
E
6 s
E
E
3 s
E
Auto-Stop
Drive
Press the E button of the setting switch for 6 seconds.
Move the motor to the lower end position with the UP or
DOWN button.
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out
at the end of the end position setting.
Run against the limit stop at the top without stopping;
the motor stops automatically.
The end positions are now set and the rotation direction
assignment is correct. Perform a test run.
30