Replacing The Battery - Cola TOPFIRE 70 Manuel D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

MENU 04 – Select language
With this selection it is possible to set the desired language from those available.
MENU 05 – Standby mode
By selecting ON in STANDBY mode the insert shuts down automatically after the room temperature has remained
above the SET value for a fixed time.
The next automatic relighting will be possible only when the room temperature falls below the set value entered in
the parameters table (default 2°C).
By selecting OFF the insert activates the modulation function but not the STANDBY mode. Therefore when the
temperature exceeds the set value, the insert operates at minimum power.
MENU 06 – Buzzer mode
With this selection it is possible to activate or deactivate the insert acoustic signals for alarms and for pressing
buttons on the remote control.
MENU 07 – Initial load
Allows the preloading of pellets for a given time. This function can only be activated when the insert is off and is
used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P3.
MENU 08 – Stove/insert status
This selection is reserved for the COLA service center authorized technician.
MENU 09 – Technician settings
This selection is reserved for the COLA service center authorized technician.
Modification of the technical parameters of menu 09 must be done by authorized and competent
personnel; any random changes made can cause serious damage for which COLA declines any liability.
MENU 10 – Installer settings
This selection is reserved for the qualified installer and/or COLA service center authorized technician.
MENU 11 – ECO mode
Selecting ON in ECO mode limits insert operation to modulation, i.e. at minimum power. The display shows the
message ECO MOD.
4.2.5

Replacing the battery

The remote control is powered by two batteries located in the back of the device. For insertion and possible
replacement, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the AAA 1.5 V batteries, respecting the
polarity;
- Close the remote control
- Keep the remote control away from direct heat sources and water.
- The battery of the remote control must be replaced and disposed of in a safe way,
respecting the local regulations;
Cover
61
TOPFIRE 70 – TOPFIRE 80

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Topfire 80

Table des Matières