The remote control (model with 6 button) is powered by a 3-volt CR2025 type battery (included) located in the
bottom of the device.
Also remove the insulation before use.
follows:
- Operate the lever indicated;
- Pull out the battery tray and replace the battery (3-volt CR2025 model) respecting the polarity;
- Insert the tray;
- Check proper functioning.
4.7.1 Replacing the battery
The remote control comes without the battery; it works
with a battery placed in the lower part of the device.
To fit or replace the battery, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the 12V battery model p23ga, respecting the polarity;
- Close the remote control;
- Check that it works properly;
- Keep the remote control away from heat sources and water.
- The battery of the remote control must be replaced and disposed of in a safe
way, respecting the local regulations.
4.8 Thermostat - external chronothermostat
The unit controls the room temperature by means of its own digital thermostat whose
function is to detect the temperature through a probe and lower the heat output when
the set temperature is reached.
To use an external thermostat, contact an authorised technician and proceed as
follows:
- turn off the power by means of the main switch on the back and detach the power
cable;
- remove the side panel to access the electronic controller;
- referring to the wiring diagram, connect the two wires of thermostat to the respective
board TERM terminals;
- refit everything and check correct operation.
The setting procedure is as follows:
- external thermostat:
- external chronothermostat:
All the menu functions do not change for each of the settings and signalling of the
connection occurs with lighting up of the segment LED on the status bar of the
display.
4.9 Idle period (end of season)
If the stove is not used for long periods, and/or at the end of each season, it is advisable to proceed as follows
- remove all the pellets from the hopper;
- disconnect the power and remove the power cable;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- protect the stove from dust with suitable covering;
- store in a dry and safe place protected from atmospheric agents.
SET the temperature to 7°C;
SET the temperature to 7°C and disable the chrono
functions from the menu 03-01.
53
For its insertion and possible replacement, proceed as
battery tray
lever
SABINA