Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Model 6 buttons
The remote control allows the following operations:
4.7.1 Replacing the battery
The remote control (model with 6 button) is powered by a 3-volt CR2025 type battery (included) located in the
bottom of the device.
Also remove the insulation before use.
follows:
- Operate the lever indicated;
- Pull out the battery tray and replace the battery (3-volt CR2025 model) respecting the polarity;
- Insert the tray;
- Check proper functioning.
- Keep the remote control away from direct heat sources and water.
- The remote control battery must be replaced and disposed of safely in
compliance with local regulations;
4.8 Thermostat - external chronothermostat
The unit controls the room temperature by means of its own digital thermostat whose
function is to detect the temperature through a probe and lower the heat output when
the set temperature is reached.
To use an external thermostat, contact an authorised technician and proceed as
follows:
- turn off the power by means of the main switch on the back and detach the power
cable;
- remove the side panelling to access the electronic controller;
- referring to the wiring diagram, connect the two thermostat wires to the respective
board TERM terminals;
- refit everything and check correct operation.
The setting procedure is as follows:
- external thermostat: SET the room temperature to 7°C;
- external chronothermostat: SET the room temperature to 7°C and
All the menu functions do not change for each of the settings and signalling of the
connection occurs with lighting up of the segment LED on the status bar of the display.
Button P3: Stove lighting-shutdown
Button P1: Increase room temperature
Button P6: Increase output level
Button P5: Decrease output level
Button P2: Decrease room temperature
Button P4: Jolly
disable the chrono functions from the menu 03-01.
For its insertion and possible replacement, proceed as
battery tray
lever
56
TERMOBLITZ PLUS
Publicité
Table des Matières
