The remote control allows the following operations:
4.7.1 Replacing the battery
The remote control comes without the battery; it works
with a battery placed in the lower part of the device.
To fit or replace the battery, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the 12V battery model p23ga, respecting the polarity;
- Close the remote control;
- Check that it works properly;
- Keep the remote control away from heat sources and water.
- The battery of the remote control must be replaced and disposed of in a safe
way, respecting the local regulations.
Thermostat - external chronothermostat
4.8
The unit controls the room temperature by means of its own digital thermostat whose
function is to detect the temperature through a probe and lower the heat output when
the set temperature is reached.
To use an external thermostat, contact an authorised technician and proceed as
follows:
- turn off the power by means of the main switch on the back and detach the power
cable;
- remove the side panelling to access the electronic controller;
- referring to the wiring diagram, connect the two thermostat wires to the respective
board TERM terminals;
- refit everything and check correct operation.
The setting procedure is as follows:
- external thermostat: SET the room temperature to 7° C;
- external chronothermostat: SET the room temperature to 7° C and
All the menu functions do not change for each of the settings and signalling of the
connection occurs with lighting up of the segment LED on the status bar of the display.
Idle period (end of season)
4.9
If the stove is not used for long periods, or at the end of each season, it is advisable to proceed as follows:
- remove all the pellets from the hopper;
- disconnect the power supply;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- protect the stove from dust with suitable covering;
- store in a dry and safe place protected from atmospheric agents.
L : LED lit up by pressing any button
Button P1+P6 : Stove lighting-shutdown
Button P1: Increase room temperature
Button P6: Increase output level
Button P5: Decrease output level
Button P2: Decrease room temperature
disable the chrono functions from the menu 03-01.
63
TERMO-FOCUS M