Remote Control; Replacing The Battery - Cola TERMO-PERLA Manuel D'installation, D'utilisation Et D'entretien

4.6.6 Menu 07 – initial loading
Allows the preloading of pellets for a given time. This function can only be activated when the stove is off and cold
and is used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P4.
4.6.7 Menu 08 – stove status
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.8 Menu 09 – settings by technician
This selection is reserved exclusively for the authorised COLA service centre technician.
Modification of the technical parameters of menu 09 must be done by an authorised and competent
technician; any modifications made randomly can cause serious damage for which COLA declines any
liability.
4.6.9 Menu 10 – settings by installer
This selection is reserved exclusively for the authorised COLA service centre technician.
4.6.10 Menu 11 – ECO mode
The selection ON in the ECO mode limits the stove to operate in modulation, i.e. at minimum power and minimum
ventilation. The display shows NIGHT ECO and the corresponding symbol lights up.
4.7

Remote control

The remote control is a device that transmits through an infrared diode. Therefore it must be pointed towards the
receiver unit fitted in the control panel.
The remote control allows the following operations:
P1 and P3: Buttons to set the power
level
P5: Button for accessing the MENU
P7: Button to activate/deactivate
ECO mode
P9: On/Off button and for exiting the
MENU

4.7.1 Replacing the battery

The remote control is powered by a 3-volt CR2025 type battery located in the bottom of the device. For its insertion
and possible replacement, proceed as follows:
- Operate the lever indicated;
- Pull out the battery tray and replace the battery ( 3-volt CR2025 model ) respecting the polarity;
- Insert the tray;
- Check proper functioning.
- Keep the remote control away from direct heat sources and water.
- The remote control battery must be replaced and disposed of safely in compliance with local
regulations;
P2 and P4: Buttons for setting the
temperature
P6: Button to exit the MENU
P8: Button to activate/deactivate
STANDBY mode
P10: Button to activate/deactivate
the CHRONO function
44
TERMO-PERLA