OneTouch Verio Flex Manuel D'utilisation page 23

Setting up your system
2
Day will flash
• If the day displayed is correct,
press to confirm.
• If the day displayed is not correct,
press or
and press
You are now ready to take a test.
See the section Testing your blood
glucose in Chapter 3.
NOTE: After completing first time setup, a screen with three
dashes will appear. Once you begin testing, your last result
will appear in place of the three dashes, along with the date
and time the test was taken.
Adjusting the time and date settings after first
time setup
You can adjust the meter's time and date settings after first
time setup. Press and hold
press and hold
will appear. See page 61.
After adjusting the settings, your meter will exit settings mode
and your last result screen will appear.
to change the day
to confirm.
and at the same time. The SET screen
to turn the meter on, then
22