Leica Microsystems DM2000 Manuel D'utilisation page 127

8.7 The function keys for Leica DM3000
The front control panel features six black keys
for direct selection of an objective. Adhesive la-
bels with the corresponding objective magnifi-
cation can be attached below the objective
keys. The objective key for objective 1, which is
generally the objective with the lowest magnifi-
cation, is located on the far left. The assignment
of the keys to the objective is carried out at the
factory and is dependent upon the microscope
equipment.
The gray toggle key on the far right side is used
to switch modes.
Selecting an objective
Adhesive labels with objective magnification
In standard mode, the two function keys on the
right or the left side of the stand (Fig. 56.2) are
used to sequentially approach the objective
magnifications. Pressing the upper or lower
keys causes the objective turret to turn clock-
wise or counterclockwise. The key assignment
on the right and left side of the stand is identical
in the standard configuration.
(See the special function of the lateral function
keys → p. 51.)
In toggle mode, pressing one of the lateral func-
tion keys switches back and forth between pre-
viously learned magnifications. The factory-set
objectives can easily be customized in the
teach-in mode.
Green or yellow diodes indicate the current
mode and/or the objective currently located in
the beam path.
Toggle
Fig. 56 Leica DM3000
1 Front control panel
2 Lateral function keys
1
8. Operation
2
49