Leica Microsystems DM2000 Manuel D'utilisation page 111

Tracing device
The tracing device L3/20 (fig. 30) allows an opti-
cal overlay of large objects (next to the micro-
scope) on the microscope image. This makes it
easy to draw specimens by tracing their
outlines or superimposing scales.
Foot switch for Leica DM3000
A double foot switch can be connected to the
Leica DM3000 stand as an option to swivel in the
objectives.
The connection is located on the rear side of the
stand (31b.2).
Fig. 30 Tracing device
1 Shutter
Fig. 31a Rear side of the Leica DM2000/DM2500 stand
1 Power supply connection
6.11 Connection to the Power Supply
• After completing the assembly work, connect
the stand to the power supply using the power
cable supplied (Fig. 31a,b.1).
• When using the lamp housing or the exter-
nal power supply unit, connect them to the
power supply, too.
For Leica DM3000:
If necessary, insert the objectives after switch-
ing on the microscope.
Adhesive labels with the corresponding objec-
tive magnification are attached below the black
objective keys on the front control panel. Press-
ing the corresponding key approaches the re-
spective objective position.
The connection of a PC to the Leica DM3000
(31b.3) is only required if new objectives must
be taught in or a reassignment of the lateral
function keys must be performed. This is only
1
possible using the Leica DMControl software.
Fig. 31b Rear side of Leica DM3000 stand
1 Power supply connection
2 Foot switch connection
3 PC connection
1
1
6. Assembling the Microscope
Note:
2
3
33