Programming The User Code - SentrySafe Fire-Safe Manuel Du Propriétaire

Programmable Electronic Lock
Programming information
Three code options:
Factory code:
The safe will ALWAYS unlock using this 5 digit code (found on the
back of the owner's manual). This code cannot be deleted.
User code:
A 5 digit programmable code of your choosing that can be changed
or deleted.
Secondary code:
A second 5 digit programmable code of your choosing that can be
changed or deleted. Can only be programmed after a user code
has been activated.
NOTE: • The "C" key is a clear key. This can be used at anytime to clear the system and return to
standby mode – unless you are in delay mode (3 consecutive invalid entries).
• The 5 digit factory code cannot be deleted. However, you may add and delete
additional codes.
This safe can store up to three codes at one time. One factory code and two
additional programmable codes.

Programming the user code

To ADD a user code:
1 Press the "P" key.
2 Enter the 5 digit factory code found on the back of your owner's manual.
The light will flash green and then you will have five seconds to enter your own
3
personal 5 digit user code.
To DELETE a user code:
Press the "P" key.
1
Enter the 5 digit factory code.
2
Enter 0,0,0,0,0.
3
NOTE: • The electronic lock will NOT indicate that it has deleted the user code – please test the
code to make sure it has been deleted.
Programming the secondary code
To ADD a secondary code:
1 Press the "P" key two times.
Enter the 5 digit user code previously programmed.
2
8
The light will flash green and then you will have five seconds to enter your own
3
personal 5 digit secondary code.
To DELETE a secondary code:
Press the "P" key two times.
1
Enter the 5 digit user code.
2
3 Enter 0,0,0,0,0.
NOTE: • The electronic lock will NOT indicate that it has deleted the secondary code – please
test the code to make sure it has been deleted.
How to operate the light
The safe you have purchased may include a light. This is a long-lasting LED light. Not all safes
include a light.
The batteries that operate the keypad are the same batteries that
operate the light. If the light in your unit does not turn on, please
change your batteries. Refer to page 6 to change the batteries.
The light will turn on every time you enter your code and will remain on
for 30 seconds. The light duration has three options – off, 30 seconds,
and 60 seconds.
To turn the light off:
Press the "0" button.
1
2 Press the "P" button.
3 Press the "3" button.
To turn the light on for 30 seconds:
Press the "0" button.
1
Press the "P" button.
2
3 Press the "4" button.
To turn the light on for 60 seconds:
Press the "0" button.
1
Press the "P" button.
2
Press the "5" button.
3
NOTE: • If the light duration is 60 seconds, the battery life will be reduced at a faster rate.
9