Programmable Electronic Lock - SentrySafe Fire-Safe Manuel Du Propriétaire

Programmable Electronic Lock

NOTE: • Store code (and keys if equipped) in a secure location
(other than in the safe).
Preparing your safe for first time use
Ensure any shipping screws have been removed. Located on
1
the inside of the door.
NOTE: Your unit may or may not have a shipping screw.
• DO NOT RETURN! Questions or concerns, call us at
1-800-828-1438.
A Slide out the battery drawer on the side of the keypad.
2
Insert 4 AAA alkaline batteries (not included).
B
NOTE: Do not use rechargeable batteries or any other type
of non-alkaline battery. Do not mix old and new
batteries. Do not mix alkaline and standard batteries.
C Slide battery drawer back into keypad.
Find your code on the back of this owner's manual.
3
M100TEST
SN100TEST01*
FOR DUAL KEY/COMBINATION LOCKS ONLY
12345
Keys are located inside your safe. Be sure to remove them
before locking your safe.
WARNING
Test your code several times before putting valuables inside.
Unlocking your safe
FOR DUAL KEY/ELECTRONIC LOCKS ONLY, insert key into
1
the lock, turn to the 'unlocked' position to open the safe, then
remove the key.
This is a secondary locking feature not an override key.
The key lock needs to be in the unlocked vertical position
before entering your code..
6
Enter the 5 digit factory code found on the back of the
A
2
owner's manual.
Note: You may have to lift the handle while entering the
combination.
A green light will indicate the code is correct. You will have
B
4 seconds to turn the handle to unlock your safe.
Rotate the handle downward to open the door.
3
This may take a limited amount of force if you have a water-
resistant safe.
NOTE: • Make sure the handle is rotated all the way up in the horizontal position before
unlocking the safe.
• If you exert too much force on the handle, the handle will move without moving the
bolts. If not when this happens, you will hear a 'click.' DO NOT be alarmed. This feature
is designed to protect the bolts from being over powered by force. If this occurs, simply
exert force in the opposite direction (lifting up) until the handles 'clicks' back into place
and repeat steps 1-3 to open your safe.
• Delay mode will occur if three consecutive invalid entries have been tried. Red LED will
blink on and off to let you know the safe is in delay mode. This will cause the system
to shutdown for two minutes. DO NOT remove the batteries to restart the system it will
only increase the length of time for the system shutdown.
Locking your safe
Close the door and pull the handle upward until the handle is
1
horizontal.
For water-resistant units, additional pressure to the front,
left side of the door may need to be applied prior to rotating
the handle.
FOR DUAL KEY/ELECTRONIC LOCKS ONLY, insert key into
2
the lock, turn to the 'locked' position, then remove the key.
NOTE: If your safe does not appear to be working properly,
please check to make sure you are using NEW
alkaline batteries before contacting SentrySafe
Customer Service.
7