Programming Your Safe - SentrySafe Quick Access Pistol QAP1BE Manuel Du Propriétaire

Programmable Electronic Lock
NOTE: Store code and keys in a secure location (other than in the safe).
NOTE: SentrySafe offers a secure on-line location for the entry and retrieval of your code.
Go to www.sentrysafe.com/customercare/register_your_product and
register your safe.
Preparing your safe for first-time use
Insert key into keyhole and turn.
1
NOTE: Do not lock key inside safe – this is an override key
and will open the safe in the event that you have
lost your code.

Programming your safe

Remove the battery pack cover
1
A
Insert four AA alkaline batteries.
B
NOTE: Do not use rechargeable batteries or any other type of non-alkaline battery.
Do not mix old and new batteries. Do not mix alkaline and standard batteries.
The Quick Access Pistol Safe comes with a built-in code.
2
Factory code 1, 2, 3, 4, 1.
1 2 3 4
Press any button once to bring the safe out of standby mode,
then enter the Factory Code 1, 2, 3, 4, 1. The Green LED
will light.
IMPORTANT
All safe models initially work with the safe code 1, 2, 3, 4, 1. It is therefore important
to re-program your safe with a new user code you have personally selected to
provide maximum security. For biometric models, up to two users can enroll two
fingers each.
4
Programmable Electronic Lock
3
Pull out battery pack (keep battery pack connected
A
to wires).
Find the button located behind the battery pack.
B
Press and hold the button until the keypad flashes 3 times.
C
The LEDs remain on to indicate it is ready to accept a new
user code or fingerprint.
4
To Program an Electronic Code
Enter a user code that is four, five or six digits long.
A
A successful programming of the user code is indicated
B
when the LED light flashes green three times.
–OR–
To Program Primary User Fingerprints
(For select models with biometric lock only)
Press and hold the Reset button until the keypad flashes 3
A
times. The LEDs remain on to indicate it is ready to accept a
new fingerprint.
Swipe first finger across fingerprint scanner. You will need
B
to swipe this finger multiple times. The LED light will flash
green once for each valid scan.
When the enough valid scans have been done (usually
C
5-10 scans) the LED light will flash green three times. There
is a slight delay before the fingerprints are enrolled and the
LED flashes green 3 times.
After enrolling your first finger, immediately swipe your
D
second finger across the fingerprint scanner. You will need
to swipe this finger multiple times. The LED light will flash
green once for each valid scan.
To Erase Primary User Fingerprints
5
Press and hold the Reset button until the keypad flashes 3
A
times. The LEDs remain on to indicate it is ready to accept a
new fingerprint.
Swipe a finger across fingerprint scanner only once, then
B
wait 10 seconds. The Red LED will flash 3 times to indicate
the Primary User fingerprints have been erased.
Write down your user code, and keep it in a secure location.
6
Or visit www.sentrysafe.com/customercare/register_your_
CONFIDENTIAL
product to store your user code.
5