Operating The Light - SentrySafe Fire-Safe Série Manuel Du Propriétaire

The light will flash green and then you will have five seconds to enter your own
3
personal 5 digit secondary code.
To DELETE a secondary code:
Press the "P" key two times.
1
Enter the 5 digit user code.
2
Enter 0,0,0,0,0.
3
NOTE: • The electronic lock will NOT indicate that it has deleted the secondary code – please
test the code to make sure it has been deleted.
How to operate the light
The safe you have purchased may include a light. This is a long-lasting LED light. Not all safes
include a light.
To turn the light off:
Press the "0" button.
1
Press the "P" button.
2
Press the "3" button.
3
To turn the light on for 30 seconds:
Press the "0" button.
1
Press the "P" button.
2
Press the "4" button.
3
To turn the light on for 60 seconds:
Press the "0" button.
1
Press the "P" button.
2
Press the "5" button.
3
NOTE: • If the light duration is 60 seconds, the battery life will be reduced at a faster rate.
The batteries that operate the keypad are the same batteries that
operate the light. If the light in your unit does not turn on, please
change your batteries. Refer to page 6 to change the batteries.
The light will turn on every time you enter your code and will remain on
for 30 seconds. The light duration has three options – off, 30 seconds,
and 60 seconds.
9