Operating Sound Features; Bolting Down Your Safe; Bolt-Down Instructions - SentrySafe Fire-Safe Manuel Du Propriétaire

Operating Sound Features

Operating sound features
For Programmable Electronic Lock Only
the tones of the key pad may be turned on and off depending on user preference.
Turn sound off:
Press "O".
1
2 Press "P" key.
3 Press "1".
Turn sound on:
Press "O".
1
Press "P" key.
2
3 Press "2".
10

Bolting Down Your Safe

Bolt-down instructions

WARNING
Product is not water resistant once it is bolted down. The ETL verified water resis-
tance claim applies to product prior to the application of a bolt-down kit.
Bolt-down kit contents (in select models only):
• 2 lag screws
• 2 washers
• 2 masonry anchors
Tools needed to bolt safe to the floor:
• Drill
• Wrench
• 7 ⁄ " (11 mm) drill bit – for drilling into the safe
16
• 9 ⁄ " (7.2 mm) drill bit – for drilling into a wood floor
32
• ⁄ " (9.5 mm) drill bit – for drilling into a masonry floor
3
8
Warning: • DO NOT drill from any location inside the safe.
• DO NOT bolt through the walls.
Tip the safe onto its right side (door hinges horizontal with the floor).
1
Unlock the safe and open the door. Look to the bottom of the
2
safe for two indentations on the feet in opposite corners. Using
the ⁄ " (11 mm) bit; drill a hole through each indentation
7
16
perpendicular to the bottom of the safe. DO NOT drill from
any location inside the safe.
Tip the safe upright, place the safe in the desired location and open the door.
3
Use a screw or pencil to mark the floor through both holes.
4
11