Operating The Light; Bolting Down Your Safe - SentrySafe Fire-Safe Serie Manuel Du Propriétaire

Operating the Light

How to operate the light
The safe you have purchased may include a light. This is a long-lasting LED light. Not all safes
include a light.
The batteries that operate the keypad are the same batteries that
operate the light. If the light in your unit does not turn on, please
change your batteries. Refer to page 6 to change the batteries.
The light will turn on every time you enter your code and will remain on
for 30 seconds. The light duration has three options – off, 30 seconds,
and 60* seconds.
To turn the light off:
Press the "0" button.
1
Press the "P" button.
2
Press the "3" button.
3
To turn the light on for 30 seconds:
1 Press the "0" button.
Press the "P" button.
2
Press the "4" button.
3
To turn the light on for 60 seconds:
1 Press the "0" button.
2 Press the "P" button.
Press the "5" button.
3
*If the light duration is 60 seconds, the battery life will lessen at a faster rate.
10

Bolting Down Your Safe

Bolt down instructions
Warning: DO NOT drill through bolt cups.
Warning: DO NOT bolt through the walls.
Warning: Do NOT drill from any location inside the safe.
Bolt down kit contents (in select models only):
• 2 lag screws.
• 2 washers.
• 2 masonry anchors.
Tools needed to bolt safe to the floor:
• Drill.
• Wrench.
• ⁄ " (11 mm) drill bit – for drilling into the safe.
7
16
• ⁄ " (7.2 mm) drill bit – for drilling into a wood floor.
9
32
• 3 ⁄ " (9.5 mm) drill bit – for drilling into a masonry floor.
8
1
Close the door. Tip the safe onto its left side (door hinges horizontal with the floor).
Look to the bottom of the safe for two indentations on the feet
2
in opposite corners. Using the
through each indentation perpendicular to the bottom of the
safe. Do NOT drill from any location inside the safe.
3
Tip the safe upright, place the safe in the desired location and open the door.
4
Use a screw or pencil to mark the floor through both holes.
For products that do not come with a bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
⁄ " (11 mm) bit; drill a hole
7
16
11