Mechanical Combination Lock - SentrySafe Fire-Safe Manuel Du Propriétaire

Mechanical Combination Lock

NOTE: • Store combination (and keys if equipped) in a secure
location (other than in the safe).
• Combination can not be changed.
Preparing your safe for first time use
Ensure any shipping screws have been removed. Located on
1
the inside of the door.
NOTE: Your unit may or may not have a shipping screw..
• DO NOT RETURN! Questions or concerns, call us at
1-800-828-1438.
Find your combination on the back of this owner's manual.
M100TEST
2
SN100TEST01*
FOR DUAL KEY/COMBINATION LOCKS ONLY
10-22-33
RLR
Keys are located inside your safe. Be sure to remove them
2075
before locking your safe.
WARNING
Test your combination several times before putting valuables inside.
Unlocking your safe
FOR DUAL KEY/COMBINATION LOCKS ONLY, insert key into
1
the lock, turn to the 'unlocked' position, then remove the key.
This is a secondary locking feature not an override key.
The key needs to be in the vertical unlocked position to open
the safe.
Rotate dial to '0', then rotate right (clockwise)
2
passing '0' three times, continue rotating until you reach the
first number in your combination.
Rotate dial to the left (counterclockwise). Go PAST the second
3
number of your combination ONCE and stop the SECOND time
the dial reaches the number.
4
Rotate the dial to the right (clockwise), stop when you reach
4
the third number in your combination.
Rotate the handle downward to open the door.
5
This may take a limited amount of force if you have a
water-resistant safe.
NOTE: • Make sure the handle is rotated all the way up in the horizontal position before
unlocking the safe.
• If the door does not open easily, repeat steps 1-5.
• If you exert too much force on the handle, the handle will move without moving the
bolts. If this happens, you will hear a 'click.' DO NOT be alarmed. This feature is
designed to protect the bolts from being overpowered by force. If this occurs, simply
exert force in the opposite direction (lifting up) until the handles 'clicks' back into place
and repeat steps 1-5 to open your safe.
Locking your safe
Close the door and pull the handle upward until the handle
1
is horizontal.
For water-resistant units, additional pressure to the front,
left side of the door may need to be applied prior to rotating
the handle.
Spin the dial at least 2x to the right (clockwise).
2
FOR DUAL KEY/COMBINATION LOCKS ONLY, insert key
3
into the lock, turn to the 'locked' position, then remove the key.
5