Battery Installation / Opening; Programming Your Safe - SentrySafe CHW30300 Manuel Du Propriétaire

Battery Installation / Opening

NOTE: Store code in a secure location (other than in the safe).
NOTE: SentrySafe offers a secure on-line location for the entry and retrieval of your code.
Go to www.registermysafe.com and register your safe.
Battery Installation
Insert a credit card, identification card, or another card of a similar size in the
1
center slot of the battery cover. Once inserted, Remove the card, the battery
cover will pop out attached to your card.
Insert a new 9 volt Alkaline battery in the indicated area.
2
Reinstall the battery cover by inserting the left side with the two tabs first.
3
NOTE: Do not use rechargeable batteries or any other type of non-alkaline battery.
To Open
For first time use, enter the factory code, located on the back of this owners
1
manual, on the keypad. A green LED light will flash to indicate acceptance of
entry. Please allow for a brief delay for the lock to actuate.
Press down on lid and pull up on latch.
2
NOTE: If an incorrect code is entered three times, the safe will enter lockout mode.
(Red LED blinks slowly for two minutes.) Please refer to troubleshooting.
4

Programming Your Safe

Programming or Resetting Your Personal Code
Open the safe, then press and hold the reset button, located on the top of
1
the keypad, until the green LED flashes.
Enter a new 4-6 digit personal code on the key pad. The safe will
2
acknowledge each acceptable keypress when green LED flashes.
Note: The safe will time out if there is no key entry within 10 seconds.
If the new personal code is 6 digits, the safe will accept immediately. If the
3
new personal code is 4 or 5 digits, the code will be accepted 10 seconds
after the last key press. The safe will go into Standby mode if fewer than 4
digits are entered.
Once the new personal code is accepted, the safe will automatically save
4
and exit to Standby mode without additional indication.
Test the personal code before closing the safe. If the code is invalid,
5
Repeat steps 1-4.
Confidential – Write down personal code, and keep it in a secure location.
Or visit www.registermysafe.com to store your personal code.
NOTE: The personal code programmed will not be erased when the battery power is removed.
To Close
Press down on lid. Your safe is now securely locked.
1
5