Monogram ZET1P Manuel Du Propriétaire page 39

Four mural à convection de 76 cm (30 po)
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Save time
& money!
PROBLEM
CLOCK AND TIMER
DO NOT WORK
OVEN
TEMPERATURE
TOO HOT OR
TOO COLD
OVEN DOOR WILL
NOT OPEN AFTER
A CLEAN CYCLE
LOCKED
FLASHES IN
THE DISPLAY
LOCKED LIGHT
IS ON WHEN YOU
WANT TO COOK
F9 FLASHES
IN THE DISPLAY
DISPLAY GOES
BLANK
DISPLAY FLASHES
UNABLE TO GET
THE DISPLAY TO
SHOW SF
"PROBE" APPEARS
IN THE DISPLAY
POWER OUTAGE,
CLOCK FLASHES
STEAM FROM
THE VENT
"BURNING" OR
"OILY" ODOR
EMITTING FROM
THE VENT
STRONG ODOR
FAN NOISE
POSSIBLE CAUSE
• A fuse in your home may be blown or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
• Oven controls improperly set. See the Clock and Timer sections.
• Oven thermostat needs adjustment. See the Oven thermostat
adjustment section.
• The oven is too hot. Allow the oven to cool below locking temperature.
• The self-clean cycle has been selected but the door is not closed.
Close the oven door.
• The oven door is locked because the temperature inside the oven has
not dropped below the locking temperature. Turn the Oven Mode
and the Temperature knobs to OFF. Allow the oven to cool.
• The oven has a function error code. Turn the Oven Mode and the
Temperature knobs to OFF. Allow the oven to cool for one hour. Put the
oven back into operation.
• Disconnect all power to the oven for 30 seconds and then reconnect
power. If the function error code repeats, call for service.
• A fuse in your home may be blown or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
• The clock is in the black-out mode. See the Special Features section.
• Power failure. Reset the clock.
• The PROBE and the DELAY START buttons must be pushed at the
same time and held for 4 seconds.
• This is reminding you to enter a probe temperature after plugging in
the probe. Enter a probe temperature.
• Power outage or surge. Reset the clock. If the oven was in use, you
must reset it by pushing the CLOCK button, turning and pushing the
Mini-Knob to enter.
• When using the convection feature, it is normal to see steam coming
out of the oven vent. As the number of racks or amount of food being
cooked increases, the amount of visible steam will increase.
• This is normal in a new oven and will disappear in time.
• This is temporary. An odor from the insulation around the inside of the
oven is normal for the first few times the oven is used.
• A cooling fan or a convection fan (depending on the function you are using)
may turn on. This is normal. The cooling fan will turn on to cool internal
parts. It may run after the oven is turned off. The convection fan may cycle
on and off until the function is over or the door is opened.
The Problem Solver
Wall Oven
39

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zet1sZet2p

Table des Matières