Oven racks
The racks may remain in the oven during the self-
cleaning cycle without being damaged.
Periodically, after several self-clean cycles, the
oven racks may need to be lubricated using
the Graphite Lubrication shipped with your wall
oven. To order additional Graphite Lubrication,
call our National Parts Center 800.626.2002 and
reference WB02T10303.
1 Remove rack from the oven. See the Full
2 Fully extend the rack on a table or countertop.
3 If there is debris in the slide tracks, wipe it
4 Shake the graphite lubricant before opening it.
5 Repeat for the right slide mechanism of
34
extension oven racks section.
Newspaper may be placed underneath the
rack for easy clean up.
away using a paper towel. NOTE: Any graphite
lubricant wiped away must be replaced.
Starting with left slide mechanism of the rack,
place four (4) small drops of lubricant on the
two (2) bottom tracks of the slide close to the
bearing carriers.
Left side
the rack.
Right side
Care and Cleaning
6 Open and close the rack several times to
distribute the lubricant.
7 Replace the cap on the lubricant and shake
it again. Turn the rack over and repeat steps 3,
4, 5 and 6.
Rack up-side-down
8 Close the rack, turn rack
right-side-up and place in the oven. See the
Full extension oven racks section.
9 Repeat above steps for each rack.
NOTE: Do not spray with Pam
sprays.
Rack right-side-up
Wall Oven
Left side
Right side
Rack up-side-down
or other lubricant
®