Special Features; Thermostat Adjustment - Monogram ZET1P Manuel Du Propriétaire

Special
Your oven has additional Special Features that
you may choose to use.
features of
your oven
steps are repeated. The Special Features will
control
remain in memory after a power failure.
Either the Oven Mode knob and/or the
Temperature knob must be turned to OFF.
On double oven models, either the Oven Mode knob
Oven
You may find that your new oven cooks differently
than the one it replaced. Use your new oven for a
thermostat
few weeks to become more familiar with it. If you still
adjustment
think your new oven is too hot or too cold, you can
adjust the thermostat yourself.
To adjust the oven thermostat:
1 Push and hold the PROBE and DELAY START
2 Push the PROBE button. A "0" will show in the
3 Turn the Mini-Knob to adjust the oven thermostat
4 Push the Mini-Knob to enter your choice.
Tones at
At the end of a timed cycle, 3 short beeps will sound
followed by one beep every 6 seconds until the TIMER
the end of a
button is pushed. This continuous 6-second beep may
timed cycle
be cancelled. To cancel the 6-second beep:
1 Push and hold the PROBE and DELAY START
2 Push the TIMER button to choose between:
3 Push the Mini-Knob to enter your choice.
4 Push and hold the Mini-Knob for 5 seconds
30
buttons at the same time for 4 seconds until the
display shows SF (Special Features).
display.
On double wall oven models, a "0" will show in
both the upper and lower oven displays. Push the
PROBE button a 2nd time ("UPPER" will show in the
display) to set the upper oven, and push PROBE
a 3rd time ("LOWER" will show in the display) to
set the lower oven.
up to 35°F hotter or (-) 35°F cooler in 1°F
increments.
buttons at the same time for 4 seconds until the
display shows SF (Special Features).
con SF bEEP – Continuous Beeps – Reminder
beeps will sound after a timed cycle has ended
until the TIMER button is pushed.
SF bEEP – No beeps – The reminder beeps after a
timed cycle is cancelled.
to exit SF (Special Features) and return to the time
of day clock.

Special Features

Wall Oven
or the Temperature knob will have to be turned to
OFF for each oven.
NOTE: While in the Special Features mode, if the
Mini-Knob is not pushed to enter a choice after
60 seconds, the mode will be cancelled (without
changes) and the time of day will return to the
display.
The following are the features and how you may
activate them.
Double oven display shown.
2. Push to choose.
1. Push and hold at the same time to enter/exit SF.
5 Push and hold the Mini-Knob for 5 seconds
to exit SF (Special Features) and return to the time
of day clock.
Do not use thermometers, such as those found in
grocery stores, to check the temperature setting of
your oven. These thermometers may vary 20–40
degrees.
NOTE: This adjustment will only affect baking
temperatures; it does not affect broiling or self-
cleaning temperatures. The adjustment will be
retained in memory after a power failure.
Double oven display shown.
2. Push to choose.
1. Push and hold at the same time to enter/exit SF.
NOTE: On double oven models, this cancels the
end-of-cycle tone for both ovens.
3. Mini-Knob
Push to enter
choice
3. Mini-
Knob
Push to
enter choice