Fitting Instructions - R&G LP0217BK Mode D'emploi

Page | 7

FITTING INSTRUCTIONS


Remove the riders seat and remove the three bolts that secure the grab rail in place, as shown in pictures 1, 2 &
3.

Remove the threaded boss that remains once the grab rail is removed by using a 12mm spanner or socket, as
shown in picture 4.

Remove the two bolts that are shown in pictures 5 & 6 that mount the left side body panel in place before
removing the panel from the bike.

Repeat the above two stages to remove the right-side body panel.

Remove the Phillips screw that mounts the plastic exhaust surround, as arrowed in picture 7. There is also one to
remove on the other side of the bike.

The rear bodywork with exhaust surround can now be removed by lifting and pulling rearward. The two exhaust
surrounds may need to be carefully spread slightly for the bodywork to clear the OEM licence plate hanger and
tail light.

On the left side of the bike, the wiring harness should be visible. Disconnect the tail light/indicator wiring
connector, as arrowed in picture 8.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 25
Picture 27
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
Picture 26
Picture 28
info@rg-racing.com