R&G LP0217BK Mode D'emploi page 9


Re-fit the OEM bodywork starting with the tail piece that includes the exhaust surrounds by using a reverse
procedure to how it was removed, as shown in picture 26.

Use the M6 x 16mm long button head bolts (item 2) and M6 washers (item 3) to fix the rear mounting hole on
the exhaust surround to the slotted hole in the licence plate bracket, before fitting one M6 washer (item 3) and
one M6 Nyloc nut (item 7) to the exposed thread and tighten, securing the exhaust surrounds in place, as shown
in pictures 27 & 28. There is a lot of adjustability in where these exhaust surrounds sit. Please ensure they are
Page | 9
positioned so the exhaust exits as close to the centre of the hole as possible to prevent any melting issues with the
plastic.

Re-fit the two side bodywork panels to the bike in a reverse procedure to how they were removed.

Re-fit the grab rail and three bolts that secure this in place.

Re-fit the seat.

Ensure the tail tidy is securely mounted.

Check that all wiring is neatly routed and does not come into contact with the exhaust.

Re-fit the licence plate (it may require drilling).

Adjust and tighten indicators into a suitable position that remain fully visible.

Depending on local laws, attach enclosed reflector in an appropriate location.

Test the licence plate illuminator and all lights before riding.
Digital copies of these instructions are available to download from www.rg-racing.com
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other
services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is
responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G
shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or
maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident
or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for
indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service
concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G
Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 04/05/2017 (AR)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email: info@rg-racing.com