Simplex/Custom Configuration - Pentair SIATA SFE-EV PRO Manuel D'utilisation

4.3.1 Simplex/Custom configuration

When controller is programmed for a time clock control mode:
 Time of day: xx:xx with the central ":" flashing.

Day of the week – from 1 to 7
When controller is programmed for a volumetric control mode (delayed or immediate regeneration):
 Time of day and day of week, as shown on picture XX above
Alternating with

Remaining treatable volume.
When in delayed volumetric control mode, treatable water is display will switch to service status and the
regeneration icon on the controller display
planned to start at the regeneration time.
When the system is regenerating, the following information are shown on the display:
 In all cases the regeneration icon on the controller display is turned on:

When the controller is moving the valve from one position to another, it shows which cycle will be
performed: nC-- , where n represent the cycle number (from 1 to 5). Revolving bar is also displayed to
indicate that the motor is on.
 When a regeneration cycle has started but not finished, it shows what is the current regeneration
cycle step as well as the remaining time in minutes for that cycle: nCxx
will be flashing to indicate that a regeneration has been
Page 8