Pentair SIATA SFE-EV PRO Manuel D'utilisation page 20

End
Table 4: Intermediate Menu
Prescaler with programmed values. Press
change.
The option is displayed only if FP: 1
Ref. Value Description
1 14/1 14 pulses per 1 unit of volume
2 4/1
4 pulses per 1 unit of volume
3 1/1 1 pulse per 1 unit of volume
4 4/10 4 pulses per 10 units of volume
5 2/10
2 pulses per 10 units of volume
6 1/10 1 pulse per 10 units of volume
7 4/100
4 pulses per 100 units of volume
8 2/100 2 pulses per 100 units of volume
9 1/100 1 pulse per 100 units of volume
10 4/1000 4 pulses per 1000 units of volume
11 2/1000 2 pulses per 100 units of volume
12 1/1000
1 pulse per 100 units of volume
Number of regenerations before the salt alarm to light up on the
controller's display.
Press and buttons to adjust and press the regeneration button to
confirm.
Days enabled for regeneration. Display shows "dx y" where x represents
the day of the week (1-7) and y indicates whether the selected day is
enabled for regeneration "1" or disabled "0". On the upper part of the
display, enabled days are on while disabled days are not displayed.
To change the setting of the selected day (x) =
To enable or disable the selected day (y) press
The option is displayed and programmable only if SH: 0.
Calendar override for regeneration initiation: maximum number of days
between 2 regenerations. In case no regeneration occurred during this
programmed interval of day, the SFE-EV controller will automatically start
a regeneration. Press and
N.B.: This type of regeneration is carried out at the regeneration time
even on non-enabled days.
The option is displayed only if SH:1 or SH: 2 or SH: 4
Mains Electrical frequency 50 or 60 Hz. Press
When apply the changes
dif: wait the end of next regeneration Imm: immediate on programming
exit
End of programming
Page 20
and buttons to
buttons to change.
or to change.
1 1-12
OF Off-99
All
N.A.
enabled
4 Off-99
50 or
50
60
dIF or
IMM
IMM
N.A. N.A.