Pentair SIATA SFE-EV PRO Manuel D'utilisation page 21

To access this menu, press the
Access to the menu is password protected.
The Advanced programming menu contains the parameters shown in table 5 .
The parameters will be displayed one after the other. Press the button
the next.
While the parameters are being changed, the regeneration icon flashes.
All the changes made are saved when the message
programming processes are not therefore saved.
and buttons simultaneously for 5 seconds.
Enter password, to change the figure press
the key to move from one parameter to the next.
Camshaft Stop Number.
The option is displayed only for Custom system type
Camshaft Identifier.
The option is displayed only for Custom system type and is
readable only.
Modular function.
OF= disabled
On = enabled
The option is displayed only for Duplex system type
Modular flow rate activation.
Indicates the threshold value (Liters/min or M3/h) for the activation of
modular function. On the display letter A, B and circle icon blinking. The
number may be set to a maximum of 9999 if Liter/min or 999.9 if M3/h.
The option is displayed only if SH:1 or SH: 2 and St=1.
The option is displayed only for Duplex system type and only if M=1
Modular management. A= Auto
O= Override
The option is displayed only for Duplex system type and only if M=1
Regeneration inhibit activation.
Enable or disable the regeneration of both columns A and B during a
programmable time interval.
The option is displayed only for Duplex system type, if M=1 and MM=O
Inhibit regeneration Start Time.
Start time of the regeneration inhibit.
The option is displayed only for Duplex system type and only if IM=On
Page 21
to move from one parameter to
appears Parameters changed during uncompleted
.
key. Press the
0000-
0000
9999
4 1-9
N.A. N.A.
Off 0ff-On
100 0-9999
O A-O
Of On-Off
00:00
18:00
23:59