Pentair SIATA SFE-EV PRO Manuel D'utilisation page 16

The Basic menu is used to set the most common operating parameters. To access the Basic menu, press and
release the regeneration button
contains the parameters shown in table 3. The parameters will be displayed one after the other. Press the
button to move from one parameter to the next. While the parameters are being changed, the
regeneration icon flashes.
All the changes made are saved when the message End appears.
Parameters changed during uncompleted programming processes are not therefore saved.
DATA
Table 3: Basic Menu
once. Access to the menu is password protected. The Basic menu
DESCRIPTION
Enter password, to change the figure press the
key to move from one parameter to the next.
Setting the time. The current time, the selected figure and the
regeneration symbol flash while the current date is fixed. To change the
figure press the key. Press the
the next.
Day of the week. The current day flashes on the display and the time is
fixed.
To change the selection, use the
Regeneration Start time for time clock regeneration, volumetric delayed
regeneration, calendar override
programmed regeneration mode is an Interval mode, the first
regeneration will start at that programmed time. Use the UP arrow to
modify the digit, press the DOWN arrow to switch to the next digit and
press the regeneration button to confirm and switch to next parameter.
Page 16
key. Press the
key to move from one figure to
keys.
initiated regeneration. If the
DEFAULT MIN-
MAX
0000-
0000
9999
00:00-
00:00
23:59
1 1 - 7
00:00-
02:00
23:59