General Advice; Environmental Conditions - Pentair SIATA SFE-EV PRO Manuel D'utilisation

2

GENERAL ADVICE

IT IS STRICTLY FORBIDDEN FOR NOT QUALIFIED PERSONAL, TO ACCEDE TO SYSTEM'S INTERNAL
PARTS TO PERFORM ANY KIND OF TECHNICAL ACTION. BE SURE TO DISCONNECT THE ELECTRICAL
POWER AND CLOSE THE WATER INLET BEFORE OPENING THE FRONT COVER TO ACCESS INTERNAL
PARTS.
Manufacturer
PENTAIR MANUFACTURING ITALY SRL
VIA MASSACCIO, 13
56010 Lugnano di Vicopisano (PI) – Italy
Warnings
The manufacturer will not be held liable for any damages to people or properties resulting from an improper
use of the device not compliant with the following instructions.
Whenever this guide doesn't clarify all doubts about installation, service or maintenance, please contact the
technical support of the company that has installed the device.
Device installation must be done by a qualified technician according to the current standards and regulations,
using tools compliant with a device safety use and referring to that technician also for device maintenance.
In case of out of order or malfunction, before performing any kind of action on the device, please ensure to
have disconnected the transformer from the power source.
Technical data
Power supply:
230Vac, 50/60Hz, 7VA, Class II
Transient overvoltages: within the limits of overvoltage category II
Temporary overvoltages must be limited in duration and in frequency
Pollution Degree 3

Environmental Conditions

Indoor Use Only;
Altitude up to 2000 m;
Temperature from 5°C to 40°C;
Maximum relative humidity 80% for temperatures up to 31°C decreasing linearly to 50% relative humidity at
40°C;
Mains supply voltage fluctuations up to ±10% of the nominal voltage;
Page 4