Fitting Instructions - R&G CP0339BL Instructions De Montage

Picture 25

FITTING INSTRUCTIONS

Remove both the upper and lower side fairings on both sides of the bike (ensuring to

disconnect the indicators whilst taking the upper fairing off).
On the left side of the bike remove the front engine/frame bolt along with the 12mm headed

bolt just below, as shown in picture 1.
With these removed the small aluminium comma shaped spacer can be removed, as shown in

picture 2.
Remove the metal insert along with rubber grommet that fits in the hole of the mounting plate

just below the engine mount, as shown in picture 3. Keep to one side, as these will need to be
re-fitted later.
Remove the 10mm headed bolt that secures the electrical sensor in place into the engine, as

shown in picture 4. This is located to the rear of the radiator and behind the coolant pipe. With
the bolt out, rotate the sensor 90 degrees anti-clockwise to allow clearance for fitting the
mounting block later. There is no need to remove the sensor from the engine.
On the right side of the bike remove the front engine/frame bolt along with the 12mm headed

bolt just below, as shown in picture 5.
With these removed the small aluminium comma shaped spacer can be removed as on the

previous side of the bike along with the 10mm headed bolt that secures the centre of the cross
mounting bracket in place, as arrowed in picture 6.
Remove the bolt that secures the bottom of the radiator to its mount, as shown in picture 7.

The cross mounting bracket should now be relatively free to move about, but will still be

located in the centre on a rubber bung in the engine case. To allow for a bit more
manoeuvrability the metal shroud can be removed using the two bolts arrowed in picture 8 and
one bolt on the reverse. This shroud will not be able to come out, but can be dropped lower to
allow more clearance.
On the left side of the bike, remove the radiator breather hose from its mount on the radiator

filler cap and re-locate above the foam which sits between the frame and engine as arrowed in
picture 9. It should sit next to the clutch cable. Re-connect the breather hose to the filler cap
mount.
Take the right side mounting block (item 13 – M0348) and cut one of the strips of self-

adhesive foam (item 12) and stick to the inside of the V-shaped cut-out, as shown in picture
10.
Locate the mounting block onto the right side of the bike, with the block sitting between the

engine and frame mount, as shown in picture 11. The cross mounting bracket will need to be
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com
Picture 26
Email: info@rg-racing.com