R&G CP0339BL Instructions De Montage page 9

Next slide the bolt and washers through the crash protector (item 2 – B0431 with CS340) so

the head of the bolt goes into counter-bore in the crash protector and offer the assembly up to
the threaded boss on the mounting block, as shown in picture.
Tighten both crash protector assemblies until you feel some compression from inside the

protector using a 19mm socket and wrench. PLEASE NOTE THE CRASH PROTECTOR
MUST BE POSITIONED AS IN PICTURE C ABOVE WITH BIGGER END
TOWARD FRONT OF BIKE. Turn a little more so that you feel the compression increase
slightly. Then apply a quarter turn. Do not over-tighten as damage can occur to the bike. Do
not exceed 40nm of torque.
If not already fitted fit bubble sticker into recess of the crash protector cap.

Fit the crash protector cap into the crash protector.

Refit the lower fairing on the right side of the bike.

The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they
were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be
in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the
gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No
returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not
refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 27/03/2013 (AR)
CONSUMER NOTICE
R&G Racing
www.rg-racing.com Email: info@rg-racing.com