Maintenance; Machine Demolition; Environmental Informations - CLAS EQ 2100 Mode D'emploi

EQ 2100
- Make sure that the floor support is firm.
The wheel is not locked correctly.
- Tighten the locking ring nut firmly.
- Make sure that the accessories used for centring are suitable and original.
The machine has not been calibrated correctly.
- Perform the sensitivity calibration procedure.
The entered geometric data are not correct.
- Make sure that the entered data correspond to the wheel dimensions and correct them if necessary.
- Carry out the external sensor calibration procedure (width).

MAINTENANCE

The producer declines all responsibility for claims deriving from the use of non original spare parts or
accessories.
Unplug the machine from the power supply and make sure that all moving parts have been locked before
performing any adjustment or maintenance operation. Do not remove or modify any part of the machine
(except for service interventions).
Keep the work area clean.
Never use compressed air and/or jets of water to remove dirt or residues from the machine.
Take all possible measures to prevent dust from building up or raising during cleaning operations.
Keep the wheel balancer shaft, the securing ring nut, the centring cones and flange clean. These
components can be cleaned using a brush previously dripped in environmentally friendly solvents. Handle
cones and flanges carefully so as to avoid accidental dropping and subsequent damage that would affect
centring accuracy. After use, store cones and flanges in a place where they are suitably protected from
dust and dirt. If necessary, use ethyl alcohol to clean the display panel.
Perform the calibration procedure at least once every six months.

MACHINE DEMOLITION

If the machine is to be scrapped, remove all electrical, electronic, plastic and metal parts and dispose of
them separately in accordance with current provisions as prescribed by law.
ENVIRONMENTAL INFORMATION
The following disposal procedure shall be exclusively applied to the machines having the crossed-out bin
symbol on their data plate.
This product may contain substances that can be hazardous to the environment and to human health if
it is not disposed of properly.
The following information is therefore provided to prevent the release of these substances and to improve
the use of natural resources.
Electrical and electronic equipment must never be disposed of in the usual municipal waste but must be
separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product and on this page, reminds the user that the product
must be disposed of properly at the end of its life.
In this way it is possible to prevent that a non specific treatment of the substances contained in these
products, or their improper use, or improper use of their parts may be hazardous to the environment or
to human health. Furthermore, this helps to recover, recycle and reuse many of the materials contained
in these products.
78
AUTOMATIC WHEEL BALANCER 3D DIGITAL DISPLAY
+LASER POINTER