Use Of The Machine - CLAS EQ 2100 Mode D'emploi

EQ 2100
Temporary disabling of the diameter and distance sensor(EQ2000)
If the machine displays the error code Err 016 "dis out" (distance/diameter sensor not in the rest position)
at start-up, although being in rest position, it means that an anomaly has occurred in the acqui- sition
system. It is however possible to immediately (and temporarily) disable the acquisition system by pressing
the button [F + P2]. The LED [6], located on the control panel, will light up to indicate that the automatic
acquisition system is disabled and that the machine is ready for use.
Not being able to use the automatic acquisition system, sizes of the wheel must be entered manually as
described. By switching the machine off and then on, the error code will be displayed again for which it
will be necessary to repeat the procedure described above.

USE OF THE MACHINE

To use the machine, you must select or set as follows:
• Programme type (programme for wheels with steel, aluminium or special aluminium rims).
Default = programme for wheels with steel rims;
• Wheel Type (auto-vehicle, motorbike, off-road). Default = auto-vehicle;
• Dimensions of the wheel to balance. The dimensions can be entered manually (always) or partially or
fully
in automatic (only available on some models).
• Dynamic or Static balancing. Default = Dynamic;
• Display resolution X1 or X5. Default = X5;
The selections described above may be entered before or after the launch. For any variation of the
selection or data settings, the machine will run a recalculation by displaying the new values of imbalance.
Once the selections/settings have been entered, you can run a launch by pressing [P8] Start or by
lowering the wheel guard.
At the end of the launch, the machine displays the wheel imbalance values.
Apply the weights displayed by the machine at the indicated positions and then run a second test
launch. Normally, the weights should be applied at the 12 o'clock position with the exception of special
programmes for ALS2 and ALS1 aluminium.
Tableau T3.1. Programmes available
Programme Wheel
type material
STD Steel
Alumi-
ALU1
nium
Alumi-
ALU2
nium
Alumi-
ALU3
nium
Alumi-
ALU4
nium
Alumi-
ALU5
nium
Alumi-
ALS1
nium
Alumi-
ALS2
nium
(1)Available only for some versions.
48
AUTOMATIC WHEEL BALANCER 3D DIGITAL DISPLAY
+LASER POINTER
Weight position along the rim sec-
tion
Default
Default
Default
Default
Default
Default
Default for the internal weight, pro-
vided by the user for the external
weight or laser pointer
PLaser pointer
Automatic
acquisition(1)
2 sensors Start-up default
Forcibly set when the
2 sensors Motorbike Programme Type
is selected
2 sensors
2 sensors
2 sensors
2 sensors
1 sensor
1 sensor
Notes