Optimisation - CLAS EQ 2100 Mode D'emploi

EQ 2100

OPTIMISATION

The optimisation programme is used to minimise the amount of balancing weights to be applied
on the rim by opposing the imbalance of the rim to that of the tyre.
Therefore, use this programme when the wheel requires the application of heavy balancing
weights. To access the optimisation programme, proceed as follows:
1. Press [F+P4]. The display will show the options shown in figure F5.1. Press [P4] or [P5] and
choose the option oPt-1- to continue, or the option oPt rEt to return to the operating programme.
Press [F+P4] to confirm the chosen option;
Note: you can exit the calibration procedure at any time by repeatedly pressing [F+P4] .
2. If the wheel's static imbalance is less than 12 grams, the machine will display the message
shown in Figure F5.2 for a second and then will automatically exit the optimisation programme.
If the wheel's static imbalance is instead greater than or equal to 12 grams, the message shown
in Figure F5.3 will be displayed;
Figure F5.3. "Bring the valve to the 12 o'clock position" message
AUTOMATIC WHEEL BALANCER 3D DIGITAL DISPLAY
+LASER POINTER
Figure F5.1. Access to the Optimisation programme
Figure F5.2. Optimisation Programme not possible
63