Troubleshootings - CLAS EQ 2100 Mode D'emploi

EQ 2100

TROUBLESHOOTINGS

Below is a list of faults that may occur and that the user can solve if the cause is found among those
indicated.
For any other malfunction or fault call in the technical support centre.
Machine does not switch on (monitor remains switched off)
No power at the socket.
- Make sure that the mains power is present.
- Check the electrical power circuit in the workshop.
The machine plug is defective.
- Check if the plug is working properly and replace it if necessary.
One of the FU1-FU2 fuses of the rear electrical panel has blown.
- Replace the blown fuse.
The monitor has not been switched on (only after installation).
- Switch on the monitor by pressing the button located on the front of the monitor.
The monitor's power supply connector (located on the rear of the monitor) is not correctly inserted.
- Check for proper insertion of the connector.
The diameters and width values measured with the automatic measuring devices do not match the rated
values of the rims.
The sensors have not been positioned correctly during measurement.
- Bring the sensors to the position shown in the manual and follow the instructions in the WHEEL DATA
ENTRY section.
The external sensor has not been calibrated.
- Perform the sensor calibration procedure. See warning instructions at the end of the SENSOR CALIBRATION
section.
The automatic measuring devices are not working
The sensors were not at rest at start-up (A10) and the Manual data entry icon was selected, thus disabling
the automatic sensor management (E10).
- Return the sensors to the correct position.
START has been pressed and the wheel fails to spin (the machine does not start)
The wheel guard is raised (the "A Cr" message is displayed).
- Lower the guard.
The wheel balancer provides unsteady unbalance values
The machine was jolted during the spin.
- Repeat the wheel spin while making sure that nothing affects machine operation while acquisition is in
progress.
The machine does not firmly rest on the floor.
- Make sure that the floor support is firm.
The wheel is not locked correctly.
- Tighten the locking ring nut firmly.
Several spins are to be performed to balance the wheel
The machine was jolted during the spin.
- Repeat the wheel spin while making sure that nothing affects machine operation while acquisition is in
progress.
The machine does not firmly rest on the floor.
AUTOMATIC WHEEL BALANCER 3D DIGITAL DISPLAY
+LASER POINTER
77