CLAS EQ 2100 Mode D'emploi page 73

EQ 2100
By pressing this button, the machine alternates the material type of the balancing weights: if the
selected material is Iron/Zinc, select Lead and vice versa. This selection is maintained even when
the machine is shut-down.
The option relative to the type of material selected will appear on the display for a second.
Note: if Lead has been selected as material, at every machine start-up, a message indicating the
selection of this
material will appear for one second after the initial test. See figure F9.2. This signal will not
be viewed if Iron/ Zinc is selected as material. Ce message n'apparait pas lorsque le matériau
sélectionné est le fer/zinc.
[F+P3] Exit the SERVICE mode
This button allows the machine to exit the SERVICE mode and return to the NORMAL mode.
[F+P4] Read launch number counter
By pressing this button, the total number of balancing launches run by the machine will be
displayed. The
number of launches is shown on both displays. Figure F9.3 shows as an example of a machine's
display that has run 1,234 balancing launches.
Fig. F9.3 - Display of the number of the balancing launches
Balancing launches that were interrupted are not included in the total count of balancing launches
(for example, those stopped by pressing [P10] Stop or those interrupted by raising the wheel
guard) and all those run in the SERVICE mode.
[F+P5] MENU Parameters
The Menu parameter is reserved for the technical support personnel and therefore is not described
in this
manual. Access to this menu is protected by password.
[F+P6] USB port
This button is not currently used in Service mode. By pressing this button, the writing Usb will
appear on
the display for one second.
AUTOMATIC WHEEL BALANCER 3D DIGITAL DISPLAY
+LASER POINTER
Figure F9.2. Selection of the Lead balancing weights
73