CLAS EQ 2100 Mode D'emploi page 74

EQ 2100
MENU Test Programmes
This menu allows running tests for some machine functions. The Menu has the following options:
• Enc Encoder disc test;
• RPM Number of shaft RPMs test;
• SIG Pick-up signals test;
• dPy Display test.
• tAS Keypad test;
• UFc Converter voltage-frequency test.
• Ret Returns to the Service mode
To scroll through the different menu options, press [P4] or [P5] until the desired option is viewed,
then press [F+P9] to confirm the selection.
Note: the test programmes listed are mainly reserved for technical support personnel but may
also be run by end users as it does not impair machine operation.
EnC Encoder disc test
This test allows controlling the function of the encoder which informs the machine on the angular
position of the shaft. A number indicating the angular position will appear on the right display;
this number must be between 0 and 255. To exit the test programme, press [F+P9] .
rPM number of shaft RPMs test
This test allows controlling the number of shaft RPMs during the launch. A number indicating the
speed of the shaft will be viewed on the right display.
By pressing [P8] Start
number of shaft RPMs. To exit the test programme, press [F+P9] .
SIG Pick-up signals test
This programme allows checking the pick-up signal. To run the test, you will need to mount a
balanced wheel with steel rim, 15" in diameter and 6" in width (or more similar as possible), on
the machine. A 50 g weight must be applied the external side of the wheel.
By pressing [P8] Start, the machine will run continuous spinning and the pick-up signals respect
to the three attenuation processes (Attenuation 1, Attenuation 2, Attenuation 4) will appear on
the display in sequence.
To complete the test, press [P10] Stop or raise the wheel guard. To exit the test programme,
press [F+P9].
dPy Display test
The display test program will light up all the LEDs and the 7-segment displays in sequence so
you can check their functioning. To turn on all the LEDs and display segments in sequence, press
[P4] or [P5].
To exit the test programme, press [F+P9].
tAS Keypad test
The keypad test programme is used to check the operation of all the keys on the control panel.
Every time a button is pressed, the code of the same key will appear on the display: for example,
pressing [P8] Start the code "P8" will be viewed, pressing [P10] Stop the code "P10" will viewed
and so on. The code of the key [P7] is not displayed.
To exit the test programme, press [F+P9].
Note: To run the keyboard test, the wheel guard must be raised or the display will always show
the code of the key [P10] Stop. This occurs because wheel guard and the [P10]
share the same input line to the electronic control board.
74
AUTOMATIC WHEEL BALANCER 3D DIGITAL DISPLAY
+LASER POINTER
the machine will run a launch and at the end of this, it will display the
Stop button