CLAS EQ 2100 Mode D'emploi page 45

EQ 2100
Keypad
to the reference numbers of the key, the icons of the same keys are displayed to facilitate reading.
The ten buttons have a main function indicated by a symbol in the big circle, and a secondary
function indicated by the symbol in the small circle located alongside.
Some of the secondary functions feature a LED to indicate their activation. The keys [P7], [P8]
Start and [P10] Stop do not have a secondary function.
The secondary function of the keys is identified in this manual with the codes from [F+P1] to
[F+P9] as shown in Figure 1b.
To access the secondary function of a key, press the key [P7] together with one of the keys for
which you want the secondary function simultaneously and then release both the keys
Secondary function of the key.
This part consists only of a
graphic symbol. A LED indi-
cates when the secondar y
function is activated.
Table T1a. Settings, programmes and Menu available in the SERVICE mode, press F+P3 to
enter the mode
Key Setting/programme or menu
MENU programme for sensor cali-
[P1]
bration
[P2] Not used
[P3] Machine calibration
[P4] Select grams/ounces
[P5] Select inches/mm
Select the imbalances threshold
[P6]
view
[P9] Not used
AUTOMATIC WHEEL BALANCER 3D DIGITAL DISPLAY
+LASER POINTER
Main function of the key. This is the
sensitive part that must be pressed
Key Setting/programme or menu
[F+P1] Not used
[F+P2] Select weight material in Fe/Zn, or P
Exit SERVICE mode
[F+P3]
(return to the NORMAL mode)
[F+P4] Read counter with the no. of launches
Parameters MENU
[F+P5] (Menu with password reserved for tech- nical
service)
USB port
[F+P6]
Not used
[F+P9] Test Programme MENU
F.1- a
F.1- b
45