Fitting Instructions - R&G LP0121 Instructions

PICTURE 9

FITTING INSTRUCTIONS


Remove the seat unit using the key.

Remove the 8 bolts that secure the plastic undertray in place, as shwon in picture 1. Then rest the
lower half of the plastic undertray on the rear tyre.

Disconnect the license plate light and remove the cable that operates the lock from its mechanism.

Remove the lock from the plastic undertray by removing the large plastic nut on the rear, as shown
in picture 2.

Disconnect the indicators and pull the upper half of the rear undertray away from the bike. Now
access can be gained to the rear light connection, which can be removed.

Remove the two Torx bolts that secure the rear light onto the plastic, as arrowed in picture 3.

Remove the exhaust valve controller, as shown in picture 4. This can be done by removing the nut
and bolt (on the underside) of the front mount and the top bolt on the rear mount. These are rubber
mounted – remove the rubber mount from the front mount but leave the rubber mount on the rear.

Now offer up the spacers onto the exhaust valve controller. The spacers are stepped in order to
locate in the exhaust valve controller. The longer spacer (item 12 – 13mm long) fits on the front
with the shorter (item 13 – 10.5mm long) on the rear, as shown in picture 5.

Place a M6 penny washer onto the M6x20mm bolt (item 14) and locate into the rear mount. This
bolt should locate through the spacer and into the rubber mount.

Place a M6 penny washer onto the M6x25mm bolt (item 15) and locate into the front mount. This
bolt should locate through the metal mount and then the spacer, with another penny washer on the
exposed thread along with the M6 nyloc nut. The mount for this is slotted, so ensure the assembly
is pushed back fully into its correct location.

Now take the R&G license plate bracket (item 1) and fit the original light. This can then be
tightened using the two Torx bolts, as shown in picture 6. Fit the new license plate illuminator to
the license plate bracket and using a small amount of superglue stick the light shroud in position.
(Please use the heatshrink (item 12) to protect the new license plate illuminator wires)

Feed all the wires through the central hole in the licence plate bracket.

Re-fit the lock mechanism to the R&G undertray (item 2).

Now fit the rear indicators onto the undertray. If re-using the original indicators remove them from
the original plastic undertray. To fit into the R&G licence plate bracket, the rubber extensions need
to be removed from the indicator. This can be done by removing the 5mm allen key bolt from
inside and sliding the rubber off the cable.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 10
R&G Racing
www.rg-racing.com Email: info@rg-racing.com