Profibus Connections (Harsh Enclosure); Profibus Connections (Panel Mount Enclosure) - Mettler Toledo IND780 Manuel D'installation

IND780 Installation Manual
PROFIBUS Connections
(Harsh Enclosure)
The PROFIBUS connection to the harsh enclosure is made using a straight nine pin
connector inside the IND780 enclosure. Follow the instructions included with the
connector to terminate the wires. Figure 2-64 shows the PROFIBUS module for use
in the Harsh Enclosure, with its connector at upper right.
Figure 2-64: PROFIBUS PLC Module for Harsh Enclosure
Follow the wiring instructions included with the connector to terminate the wires.
PROFIBUS Connections
(Panel Mount Enclosure)
The PROFIBUS connection to the Panel Mount enclosure is made using a straight
nine-pin connector. The connector will extend through the cutout in the back panel
of the terminal. This connector (or an equivalent) is a standard METTLER TOLEDO
part # 64054361. The connector is not supplied by METTLER TOLEDO as part of
the option.
Attach the nine-pin mating plug to the connector. Pin assignments are shown in
Figure 2-65. Follow the wiring instructions included with the connector to terminate
the wires.
Figure 2-65: PROFIBUS 9-Pin Connector Assignments
2-39