Power Requirements; Ethernet And Usb Connections - Mettler Toledo IND780 Manuel D'installation

generating equipment. To confirm ground integrity, use a commercial branch
circuit analyzer. If adverse power conditions exist, a dedicated power circuit or
power line conditioner might be required.
FOR CONTINUED PROTECTION AGAINST SHOCK HAZARD CONNECT TO
PROPERLY GROUNDED OUTLET ONLY. DO NOT REMOVE THE GROUND
PRONG.

Power Requirements

The terminal requires 100 to 240 VAC (at 400 mA maximum) with a line
frequency of 49 to 61 Hz of power.

Ethernet and USB Connections

The IND780's Ethernet connection provides a 10/100 base T connection (10/100
Mb) via a standard RJ45 connector.
The standard ST30 USB connector allows USB-supported peripherals, such as
keyboards, to be attached to the IND780.
Figure 2-30 shows the locations of the Ethernet and USB connectors on the main
PCB. In this case, the PCB is mounted in a Panel enclosure.
Figure 2-30: Ethernet and USB Connections
IND780 Installation Manual
WARNING
USB Connector
RJ45 (Ethernet)
Connector
2-19