Mettler Toledo IND780 Manuel D'installation page 36

IND780 Installation Manual
Figure 2-10 shows the brackets attached to an enclosure. Note the orientation of
the enclosure relative to the brackets.
Marking Mounting Hole Position
Mark the position of the mounting holes on the vertical surface per the dimensions
shown in Figure 2-11 in inches and [mm], or by holding the terminal up to the
surface and marking through the bracket holes.
Once the mounting hole positions are established, perform one of the following
procedures, depending on the type of wall surface.
• The hardware to mount the terminal to the vertical surface is not included with the
terminal – it must be supplied locally. Ensure that the mounting hardware is
capable of supporting the weight of the terminal, which is approximately
11 lb (5 kg).
CAUTION: When carrying out the following procedures, wear proper bodily
protection, such as approved safety goggles, ear protectors and gloves.
2-8
Figure 2-10: Attaching the Wall-Mounting Brackets
Figure 2-11: Mounting Hole Pattern
Brackets