Mettler Toledo IND780 Manuel D'installation page 41

On the IND780 panel mount enclosure, cable shield terminations can be made
using the strain relief cable clamp provided on the back cover. Fold the shield
braid back evenly over the cable's insulation sheath and then fasten down the
cable and shield with the clamp and screw onto the back cover (Figure 2-19).
Figure 2-19: Shield Wire Termination, Panel Enclosure
Analog load cell, POWERCELL and PDX cable shield termination on the IND780
harsh enclosure can be made using the metal cable gland and grommet as shown
in Figure 2-24. Other cables' shield termination can be made on the ground stud
inside the enclosure (Figure 2-20).
Figure 2-20: Shield Wire Termination, Harsh Enclosure
IND780 Installation Manual
2-13