Hendi 221105 Mode D'emploi page 9

Extracting juice
• Place a container (not supplied) under the spout
assembly with the spout open.
• Remove the pusher from the feeding chute.
• Connect the power plug to a suitable electrical
supply outlet.
• Switch ON the appliance by pressing the "ON"
(green) button.
Safety protection
• This juicer will not start unless the lid with feed-
ing chute has been correctly positioned and the
safety arm locked properly. The motor will be
switched to OFF as soon as you unlock the safety
arm or press the OFF button.
Removing clogged foodstuff from lid with feeding chute
• If food is clogged, use the pusher to push it down.
If this fails to work, press the switch to the "OFF"
position and wait a while until the blade stops
runnings.
• Dsconnect the power plug from the electrical
supply outlet and remove the lid with feeding
chute.
Useful Hints
Follow these helpful hints to obtain the best results from your juicer.
• Do not put any fruit or vegetables in your juicer
until power is turned ON and the motor is start
spinning.
• Allow juicer to run for a few seconds befor start
juicing.
• Do not force the food into the juicer. Allow the
food to drop through slowly & steadily using the
pusher.
• Any fruit or vegetables that be fit will the feeding
tube can put through whole. Cut the food if it is
too big in order to fit in the feeding tube.
• Remove large pits such as peach, mango, etc., as
this will damage the blade and possibly the juicer.
• Let the juicer run for a few seconds before turn-
ing off to allow any excess juice to be extracted
from the pulp. Once turned OFF, wait until the
juicer has come to a complete standstill and has
fully cooled before disassembling.
• Fill the prepared ingredients into the hopper plate
gradually. Do not overload it. Add small pieces at
a time. Fruit pulp is ejected into the pulp con-
tainer while the extracted juice flows through the
spout into the container (not supplied).
• Use the pusher to push & guide the ingredients
through the lid with feeding chute.
• Press the "OFF" button when all the food has
been processed.
• This juicer is equipped with a powerful brake
which will stop the appliance in less than few
seconds if you unlock the safety arm while the
juicer is running.
• To switch your juicer ON again, simply lock the
safety arm properly over the lid and press the I
(ON) button.
• Wait until the juicer has come to a complete
standstill and has fully cooled before disassem-
bling.
• Clear all clogged foodstuff off the lid with feeding
chute.
• Do not recommend using overripe fruit as it will
leave too much pulp in the filter and clog the juic-
er.
• Do not pour liquids into the appliance at any time
unless you are following instructions/recipe for
making soy, rice, or nut milk.
• When using small or thin fruits or vegetables,
add many of them at the same time. For exam-
ple, insert 2 or 3 carrots at a time into the feeding
tube for best results.
• When juicing herbs or wheat grass, wrap them
in larger leafed vegetables such as spinach, cab-
bage, etc., and follow by a fruit or vegetavle that
contains an abundance of juice such as pineap-
ple, apple, etc.
• When juicing carrots that are not the same size,
do not use pusher until the largest carrot ahs
been processed. Once they have the same size,
EN
9