Hendi 221105 Mode D'emploi page 10

you can use pusher to continue until carrots have
been processed.
Cleaning and Maintenance
• Warning! Always unplug the appliance from the
electrical power outlet before cleaning & storage.
• It is NOT recommended to wash the different
parts in dishwasher.
• Immediately after use each time, use the brush
(supplied) to thoroughly clean the fine mesh
holes of the cutting blade in the basket. Be care-
ful of the sharp edges! Brush the inside under
running water, holding it up towards the light to
ensure the fine mesh holes are not blocked.
• Danger of electric shock! Do not immerse the
power cord with plug or the motor base unit in
the water or other liquids.
Parts
Pusher
Lid with feeding chute
Basket assembly with blade
Bowl
EN
Pulp container
• Dry all parts completely.
Storage
• Always make sure the appliance has already
been disconnected from the electrical wall outlet
and cooled down completely.
Troubleshooting
If the appliance does not function properly, please
check the below table for the solution.
Problem
Motor does not run after being turned ON.
Motor is running with loud noises and great vi-
brations.
Inefficient juicing result
10
• Denser vegetables (i.e. beets) and fibrous vegeta-
• Disassemble the juicer in the reverse order of as-
• Clean the motor base unit with a soft damp cloth.
IMPORTANT! Check that your detergent is suitable
for use with parts made from plastic or stainless
steel. Certain highly alkaline products (e.g. With
a high concentration of ammonia or caustic soda)
are totally incompatible with some plastics and
cause them to deteriorate very.
Description
- Immerse the parts in warm, mild dtergent for about 3 ~ 5 minutes. Never use abrasive cleaning de-
tergent.
- Rince under running water.
- Danger of hand injury! Handle with geat care with blade.
• Reassemble the juicer (See → Assembly)
• Store the appliance in a clean, dry, out of the
If you are unable to solve the problem, please con-
tact the supplier/service provider.
Possible cause
The appliance does not plug in firmly with the
electrical power outlet.
- The appliance is not well assembled.
- Too many ingredients that clogged inside the
blade in the basket assembly
- Suction feet not have firm contact with the
surface
The cutting blade inside the basket is worn.
bles (i.e.celery) should be chopped and fed slowly
into the feeding tube to reduce clogging.
sembly (See → Assembly)
reach of the children and pets.
Possible solution
Check the plug to confirm the plug in firmly.
- Unplug it and reassemble the appliance cor-
rectly (See → Assembly).
- Unplug. Clear some food & restart.
- Make sure the suction feet have contact with
the surface firmly.
Replacement of the cutting blade inside the
basket.