MINN KOTA Terrova Manuel Du Propriétaire page 20

Masquer les pouces Voir aussi pour Terrova:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

i-PILOT LINK
1
a.
Place the motor in the deployed position.
b.
The i-Pilot Link connector from the Control Head
is an 8-pin connector. Locate and identify the
correct connection for i-Pilot Link, at the base of
the Control Head.
i-Pilot Link will be paired with either Built-in
NOTICE:
MEGA Down Imaging or Universal Sonar on Ultrex,
Ulterra or Terrova. i-Pilot Link is not a feature offered on
Fortrex motors.
Paired with a Universal Sonar connector for
NOTICE:
illustration purposes. A Built-in MEGA Down Imaging
connector may be present instead.
Critical cable routing for 60" and 72" motors with i-Pilot Link and Built-in MEGA Down Imaging. Accessory Cables
NOTICE:
must exit the Coil Cord leaving three or more open coils between where the cables exit and the motor base; as assembled by the
factory. Routing the cables in any other manner will not allow the motor to stow properly.
2
ITEM(S) NEEDED
c.
If necessary, to reach the installed fish finder, take
the i-Pilot Link Ethernet Cable (Item #12) and attach
it to the i-Pilot Link cable exiting the Control Head.
If any cables need to be routed, please follow
NOTICE:
the guidelines in the Routing Connection Cables section
of these installation instructions.
d.
Install the i-Pilot Link Ethernet Cable directly into
the Humminbird fish finder, or refer to your fish
finder installation manual for complete installation
instructions. If an Adapter Cable is needed (Ethernet
Adapter Cable AS EC QDE for Helix fish finders),
install it on the end of the i-Pilot Link Ethernet Cable
and refer to your fish finder installation manual for
complete installation instructions.
20 | minnkotamotors.com
#12 x 1
i-Pilot
i-Pilot
Link
Link
Built-in MEGA
Built-in MEGA
Down Imaging or
Down Imaging or
Universal Sonar
Universal Sonar
Mount
Mount
Eight-Pin
Eight-Pin
Connector
Connector
Locking Collar
Locking Collar
i-Pilot Link Ethernet
i-Pilot Link Ethernet
Cable from Control Head
Cable from Control Head
The connectors are keyed to prevent
NOTICE:
reversed installation.
Control Head
Control Head
Coil
Coil
Cord
Cord
i-Pilot Link Ethernet
i-Pilot Link Ethernet
Extension Cable OR
Extension Cable OR
Ethernet Extension Cable
Ethernet Extension Cable
©2022 Johnson Outdoors Marine Electronics, Inc.

Publicité

Table des Matières
loading

Table des Matières