MINN KOTA Terrova Manuel Du Propriétaire page 10

INSTALLING THE TERROVA
2
c. Remove the Right Sideplate.
d. Swing the Left Sideplate out and away from the
Base Extrusion.
2c
3
e. Make sure that the Power Cables from the battery
are disconnected, or that the breaker,
if equipped, is "off."
WARNING
Make sure the motor is mounted on a level surface and is not
connected to a power source.
4
f. Place the mount as close to the centerline or keel
of the boat as possible. The motor can be installed
on either the Port or Starboard side of the boat
based on personal preference. Check placement
with the motor in the stowed and deployed positions.
Review the mounting considerations at the
beginning of the installation.
10 | minnkotamotors.com
Right Sideplate Right Sideplate
2d
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
Power Cables Power Cables
Keel Keel Deck of Boat Deck of Boat
©2022 Johnson Outdoors Marine Electronics, Inc.