Assembling The Device; Fitting The Second Column Element - Seca 286 Mode D'emploi

No.
Cylinder bolt for ultrasound head cover
q
Hex socket bolts for multifunctional display
r
Plain washer
s
Connecting nut
t
Optional cover for the multifunctional display (depends on variant)
-
Operating instructions, not shown
-

4.2 Assembling the device

Fitting the second column element

Component
The first column element is fitted to the lower part of the device at the factory.
Use an assistant to perform the rest of the assembly. Because the assembled
product is very tall, we recommend placing the components on the floor and
only standing the device up once it is fully assembled. Proceed as outlined
below.
ATTENTION!
Device damage as a result of assembly error
If the long and short threaded rods are switched, it will not be possible
to assemble the device so that it is fit for purpose.
►
Ensure that the short threaded rod is fitted when assembling the
second column element (see "Scope of delivery" on page 210).
To fit the second column element, proceed as outlined below.
1. Screw the short threaded rod hand-tight into the connecting nut of the
first column element.
Before you really get started ... • 211
English
Pcs.
1
2
1
2
1
1