Installing The Speed Controller - Reely SKY Thunder 500 ARF Notice D'emploi

All manuals and user guides at all-guides.com
f) Installing the Speed Controller
Install the speed controller (1) in the front area of
the chassis below the left rolling servo (see figure
7a, item 2).
3.5 mm plugs are already connected to the motor.
Connect these plugs to the speed controller used.
If the speed controller has open ends, weld on
the respective sockets.
The cables must be attached with a kind of cable
straps so that they can under no circumstances
get into any rotating drive parts and so that the
cable insulation cannot be chafed through.
As an alternative, the speed controller can also
be attached to a separate support in the rear area
of the chassis (see figure 7b).
Figure 7a
For this, install the support (1) with spacers (2)
behind the motor on the right side with M2.5 x 15
screws and lock nuts as shown in figure 7b.
Figure 7b
43