Reely SKY Thunder 500 ARF Notice D'emploi page 40

Figure 4b shows the right rolling servo (1) (viewed
in flight direction). Install the servo as shown in
the image.
The construction set includes suitable pushrods
(2). As shown in the figure, the pushrods are at-
tached to the linkage at the chassis and to the
servo rudder horn on the other side. For this, first
install the ball heads to the servo levers.
Shorten the fitting pushrods so that both rods are
of exactly the same length and can be installed
without any tension with the servo in its neutral
position.
Figure 4c shows the pitch servo (1) on the left
chassis side (viewed in flight direction). Install the
servo as shown in the image. The construction
set includes suitable pushrods (2). As shown in
the figure, the pushrods are attached to the link-
age at the chassis and to the servo rudder horn
on the other side. For this, first install the ball heads
to the servo levers.
Shorten the fitting pushrods so that both rods are
of exactly the same length and can be installed
without any tension with the servo in its neutral
position.
Figure 4d shows the clamping elements that must
be held against the chassis inside when screwing
on the servos.
40
All manuals and user guides at all-guides.com
Figure 4b
Figure 4c
Figure 4d