Installing The Canopy - Reely SKY Thunder 500 ARF Notice D'emploi

All manuals and user guides at all-guides.com
l) Installing the Canopy
The canopy includes a transparent part that is at-
tached with six screws (1).
Ensure that the pointy screws cannot cause any
damage – in particular at the flight battery – on
the inside.
We recommend shortening the screw heads with
a wire cutter and securing them with a drop of hot
glue.
There are two holes drilled into the left and right
sides of the canopy each. Insert the small rubber
bands into these holes (2). When installing the
canopy, the rubber bands on the left and right are
pushed over the chassis holding pegs.
Figure 11a
After installing the canopy, check that the swash
plate linkage can move freely.
Observe that there is sufficient space (at least 5
mm) and rework the canopy a little in these places.
Figure 11b
47